Table of Contents
Advertisement
M
aintenance and care
Machine storage
For best results, a few simple steps
can assure your machine is well main-
tained after your cleaning is complete.
1. Wrap power cord around Quick Release
cord Wrap™ on side of the machine.
2. Wipe all surfaces with a soft cloth. store
cleaner upright in a protected, dry area.
NOTE: You may have cleaning
solution remaining in the solution
tank. You may store your machine
this way for the next cleaning
task, but never keep dirty water in
the collection tank.
Install the replacement brush belt
1. turn the machine off and unplug from
wall outlet.
2. Remove solution and collection tanks.
3. lie machine down to access the bottom
of the machine.
4. With a Phillips head screwdriver,
unscrew the belt cover and remove.
5. Remove the brush end cap and remove belt
from brush.
6. brush can now be removed.
7. belt can be removed by sliding off the
motor pulley.
8. clean or replace belt. attach belt to
motor pulley and brush, insert brush into
right side end cap.
9. Reattach the left end cap and slide
brush back into place.
10. Replace the belt cover and screw into place.
11. manually rotate brush to make sure it rotates
freely and that the belt is aligned properly.
w w w . b i s s e l l . c o m
WARNING:
To reduce the risk of injury
from moving parts and/or
electrical shock, turn power
switch OFF and disconnect
plug from electrical outlet
before performing mainte-
nance or troubleshooting
checks.
CAUTION:
Do not store unit where
freezing may occur.
Damage to internal
components may result.
4.
5.
10.
8 0 0 . 2 3 7 . 7 6 9 1
11
Advertisement
Table of Contents
