Maintenance
Parts Removal for Cleaning/Sanitizing
Single Evaporator Ice Machines
A. Remove the water curtain
•
Gently flex the curtain in the center and remove it from
the right side.
•
Slide the left pin out.
B. Remove the water trough
•
Depress tabs on right and left side of the water trough.
•
Allow front of water trough to drop as you pull forward
to disengage the rear pins.
C. Remove the ice thickness and harvest float switches
•
Pull the float switch straight down to disengage.
•
Lower the float switch until the wiring connector is
visible.
•
Disconnect the wire lead from the float switch.
•
Remove the float switch from the ice machine.
A
22
D. Remove the water distribution tube
NOTE: Distribution tube thumbscrews are retained to
prevent loss. Loosen thumbscrews but do not pull
thumbscrews out of distribution tube.
•
Loosen the two outer screws (do not remove screws
completely they are retained to prevent loss) and pull
forward on the distribution tube to release from slip
joint.
•
Disassemble distribution tube by loosening the two (2)
middle thumbscrews and dividing the distribution tube
into two pieces.
•
Proceed to Page 21 Step 6.
D
Section 4
C
B
Part Number 040004575 9/19