Table of Contents
Advertisement
Section 2
Remote Condenser/Line Set Installation
Remote Single
Ice Machine
Circuit Condenser
M1000
*Line Set
Discharge Line
RTK
1/2" (1.27 cm)
RLK
1/2" (1.27 cm)
Air Temperature Around the Condenser
Minimum
-20°F (-29°C)
Important
Remote systems are only approved and warranted as a
complete new package. Warranty on the refrigeration
system will be void if a new ice machine head section is
connected to pre-existing (used) tubing or remote
condensers.
Part Number 040004575 9/19
Line Set*
RTK-20-R410A
MC1000
RTK-35-R410A
RTK-50-R410A
Liquid Line
5/16" (.79 cm)
3/8" (.95 cm)
Maximum
120°F (49°C)
REMOTE ICE MACHINE REFRIGERANT CHARGE
Each remote ice machine ships from the factory with a
refrigerant charge appropriate for installation with line sets
of up to 50' (15 m). The serial tag on the ice machine
indicates the refrigerant charge.
Additional refrigerant may be required for installations
using line sets between 50' and 100' (15-30 m) long. If
additional refrigerant is required, refer to the chart below for
the correct amount to be added.
Ice Machine
M1000
Important
EPA CERTIFIED TECHNICIANS
If remote line set length is between 50' and 100' (15 and
30 m), add additional refrigerant to the nameplate
charge. Refer to the table below for the model being
worked on.
Tubing length: ______________________________________
Refrigerant added to nameplate: _______________________
New total refrigerant charge: __________________________
!
Potential Personal Injury Situation
The
ice
machine
Installation of the line sets must be performed by a
properly trained and EPA certified refrigeration
technician aware of the dangers of dealing with
refrigerant charged equipment.
Installation Instructions
Refrigerant to be added for
50'-100' Line Sets
2 lbs (907g)
Warning
contains
refrigerant
charge.
11
Advertisement
Table of Contents
