PROF CFN973 Instruction Manual page 4

facilities. Contact your local government for information regarding the available collection systems. If
electrical appliance are disposed of in landfills or dumps, hazardous substances can leak into the
groundwater and get into the food chain, damaging your health and well-being.
5.2.17 This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
5.2.18 Children should be supervised to ensure that they do not play with the appliance.
6. Using Instructions
6.1 Position the fan heater so that it stands upright on a firm surface and at a safe distance from wet
environments and flammable objects.
6.2 Connect the fan heater to the mains.
6.3 Set the thermostat knob to the MAX and let the heater operate with full power.
6.4 The fan heater will switch on when the heating selector is set to one of the power settings.
6.5 Once the room reaches the required temperature, heating element will stop working but fan also
working .Once the temperature decreased, the heating element will be working. The fan heater now starts
and stops automatically and thus keeps the room temperature constant.
6.6 Before switch off the heater, pls turn the thermostat to MIN position and turn the switch to fan
position, let the appliance cool down for two minutes then turn off the heater and pull out the plug.
6.7 For CFN973, there is an additional thermostat to control the fan motor. If the temperature inside heater
is high, the thermostat will also turn on the fan heater despite that the heater is turned off. For example,
after operation, when the heater is turned off, the fan motor will still operate to cool down the
temperature inside.
7. Cleaning and Maintenance
7.1 Before cleaning the appliance, disconnect it from the socket and let it cool down. The enclosure is
easily to get dirty, wipe it often with soft sponge. For every dirty part, wipe with a sponge dipped in <50°C
water and mild detergent, then dry the heater enclosure with clean cloth. Be careful not to let the water
enter the appliance inner. Don't splash water onto the heater, never use solvent like gasoline, isoamyl
acetate toluene etc. to clean the heater, in order to protect the enclosure.
7.2 Clean the cord and plug, dry and pack it in a plastic bag.
7.3 When you store the heater, let it cool down first, keep it dry. Then cover it with a plastic bag, put in a
packing box and store it in a dry, ventilated place.
8. Trouble shooting:
You can solve many common problems easily, saving you the cost of a possible service call. Try the
suggestions below to see if you can solve the problem before calling the service centre.
Problem
The heater does not
operate, even when it is
plugged in and the
switch, thermostat are
switched on.
!
Possible cause
The plug is loose, bad connection
No power in socket outlet
The input voltage is too high or too
low
4!
Treatment
Pull out the plug, check the
connection of the plug and socket.
Then connect again.
Insert the plug in a proper socket
Use power supply according to the
rating on the label