Table of Contents
Advertisement
EN
Electric connection
Your appliance is intended to operate at a
single-phase voltage of 220-240V/50 Hz.
Before plugging in the appliance, please
make sure that the parameters of the mains
in your house (voltage, currect type,
frequency) comply to the operation
parameters of the appliance.
The information concerning the supply
voltage and the absorbed power is given on
the marking label placed in the back side of
the freezer.
The electric installation must comply
with the law requirements.
The earthing of the appliance is
compulsory. The manufacturer has no
responsibility for any damage to
persons, animals or goods which may
arise from the failure to observe the
specified conditions.
The appliance is endowed with a supply
cord and a plug (Australian type, marked
10/16A) with double earthing contact for
safety. If the socket is not the same type
with the plug, please ask a specialised
electrician to change it.
Do not use extension pieces or multiple
adapters.
Switching off
The switching off must be possible by
taking the plug out of the socket or by
means of a mains two-poles switch placed
before the socket.
Operation
Before putting into operation, clean the
inside of the appliance (see chapter
„Cleaning").
After finishing this operation please
plug in the appliance, adjust the
thermostat knob to an average
position. The green and red LEDs in the
signalling block must light. Leave the
appliance work for about 2 hours
without putting food inside it.
The freezing of the fresh food is
possible after min. 20 hours of
operation.
Appliance description
(Item. 1)
1. Door handle
2. Door
3. Lamp housing
4. Baskets
5. Tray
6. Thermostat box
7. Spacer for transport
4
Instruction for use
Advertisement
Table of Contents
