Connecting An Antenna Or Cable Tv; Connections To Your Tv - LG LRH-539 Owner's Manual

Connecting an
Connecting an
or Cable TV
or Cable TV
a Antenna a
:
Disconnect the antenna from the rear of the TV and
identify the antenna cable. If it is a round 75 ohm
coaxial cable connect it directly to the jack marked
ANT.IN on your Recorder. If your antenna cable is flat
connect it to a 300-ohm to 75-ohm antenna adaptor
(not supplied) and slip the adaptor over the ANT.IN
jack. Don't attempt to screw it into to the Recorder.
b Cable TV: b
If your cable connection has no converter or
descrambler, unscrew the cable from your TV and
attach it to the ANT.IN jack on the Recorder. If a
converter is required connect a coaxial cable from the
wall jack to the IN connector on the converter, and a
coaxial cable from the OUT connector on the
converter to the ANT.IN on your Recorder. This cable
hookup permits both TV and Recorder operation.
a
Antenna
b
To view or record a CATV channel
1 Tune the TV to the Recorder output channel (CH 3
or 4).
2 Set the Recorder channel selector to the cable
output channel. (Example: CH3)
3 Select a channel using the cable converter.
Notes:
With this connection, you cannot record one program
•
while viewing another.
If you are using a cable box to tune channels, it is not
•
necessary to do Auto Channel Set.
12
Antenna
Antenna
Antenna
OR OR

Connections to your TV

Connections to your TV
Make one of the following connections, depending on
the capabilities of your TV.
Rear of TV
VIDEO
AUDIO INPUT COMPONENT/PROGRESSIVE SCAN
INPUT VIDEO INPUT
R Y
L
A V C
RF coaxial connection
Connect the RF.OUT jack on the Recorder to the
antenna in jack on the TV using the supplied 75-ohm
Coaxial Cable (R). TV RF.OUT jack passes the signal
through from the ANT.IN jack.
How to set the Recorder's RF output channel
1. When the Recorder is turned off, press and hold
CH (V/v) on the front panel for more than five
seconds. [ch03] or [ch04] appears in the display
window.
2. Press CH (V/v) to change the RF output channel
(ch03 or ch04).
3. Tune the TV to this channel.
Video connection
Connect the DVD/VCR VIDEO OUT jack on the
Recorder to the video in jack on the TV using the
video cable supplied (V).
Note:
If you use this connection, set the TV's source selector to
VIDEO.
S-Video connection
Connect the S-VIDEO OUT jack on the Recorder to
the S-Video in jack on the TV using the optional
S-Video cable (S).
S-VIDEO
INPUT
Pr
Pb
S
Rear of the recorder