Table of Contents
Advertisement
c.
Do not use the Stapler if the Trig-
ger (39) does not turn the tool on
or off. Any tool that cannot be con-
trolled with the Trigger is dangerous
and must be repaired.
d.
Disconnect the Stapler from the air
source before making any adjust-
ments, changing accessories, or
storing the tool. Such preventive
safety measures reduce the risk of
starting the tool unintentionally. Turn
off and detach the air supply, safely
discharge any residual air pressure,
and release the throttle and/or turn
the switch to its off position before
leaving the work area.
e.
Store the Stapler when it is idle out
of reach of children and other un-
trained persons. A tool is dangerous
in the hands of untrained users.
f.
Maintain the tool with care. Keep a
cutting tool sharp and clean. A prop-
erly maintained tool, with sharp cut-
ting edges reduces the risk of binding
and is easier to control.
g.
Check for misalignment or bind-
ing of moving parts, breakage of
parts, and any other condition that
affects the Stapler's operation.
If damaged, have the tool serviced
before using. Many accidents are
caused by poorly maintained tools.
There is a risk of bursting if the tool is
damaged.
h.
Use only accessories that are
identified by the manufacturer for
the specific tool model. Use of an
accessory not intended for use with
the specific tool model, increases the
risk of injury to persons.
SKU 99637
For technical questions, please call 1-800-444-3353.
Service
a.
Tool service must be performed
only by qualified repair personnel.
When servicing a tool, use only
b.
identical replacement parts. Use
only authorized parts.
c.
Use only the lubricants supplied
with the Stapler or specified by the
manufacturer.
Air source
a.
Never connect to an air
source that is capable of
exceeding 110 psi. Over
pressurizing the tool may
cause bursting, abnormal operation,
breakage of the tool or serious injury
to persons. Use only clean, dry,
regulated compressed air at the rated
pressure or within the rated pressure
range as marked on the tool. Always
verify prior to using the tool that the
air source has been adjusted to the
rated air pressure or within the rated
air-pressure range.
b.
Never use oxygen, carbon dioxide,
combustible gases or any bottled
gas as an air source for the tool.
Such gases are capable of explosion
and serious injury to persons.
SAVE THESE
INSTRUCTIONS.
Page 4
Advertisement
Table of Contents
