Haier AD322MMAHA Operation & Installation Manual page 17

Operation instruction
Timer ON/OFF Function
Set clock correctly before starting TIMER operation
TEMP
ON
OFF
SWING
1
MODE SLEEP
HEALTH FRESH
CLOCK SET
3
TIMER HIGH/SO
2
FILTER HEAT
LIGHT LOCK
RESET CODE
1.Unit start
A
After unit start, select your desired operation mode (operation
mode will be displayed on LCD)
2.TIMER mode selection
Press TIMER button on the remote controller to change TIMER
mode. Every time the button is pressed, display of TIMER mode
changes as follows:
AM
TIMER ON
FAN
Then select TIMER mode as needed (TIMER ON or TIMER OFF).
Now
ON
3.TIMER setting (press time adjust buttons
Every time the button is pressed, time increases 10 minutes.
If the button is kept pressed, time will changes quickly.
4
Every time the button is pressed, time decreases 10 minutes.
If the button is kept pressed, time will changes quickly.
It can be adjusted within 24 hours at will.
4.Confirm setting
After setting correct time, press SET button to confirm time. Now
or
ON
Time displayed: unit starts or stops at X hour X min (TIMER ON
or TIMER OFF)
5.Cancel TIMER mode
Just press TIMER button several times until TIMER mode
disappears.
Hints:
After replacing batteries or if a power failure occurs, TIMER setting
must be reset.
Remote controller has memory function. When you use TIMER
mode next time, just press SET button after mode selection if timer
setting is the same as the previous one.
ON OFF
12:00 12:00
AM
PM
TIMER OFF
or will flash.
OFF
stop flashing.
OFF
15
Remote controller
blank
ON OFF
12:00 12:00
PM
TIMER ON-OFF
)