Air Filter - Echo SRM-266 Operator's Manual

SRM-266

Air Filter

Level 1
Parts Required:
1. Close choke (COLD START [
position). This prevents dirt from
entering the carburetor throat
when the air filter is removed.
Brush accumulated dirt from air
cleaner area.
2. Remove air filter cover and air
filter retainer from inside cover.
Brush dirt from inside cover.
3. Replace filter if it is damaged,
very dirty, or the rubber sealing
edges are deformed.
4. Remove foam pre-filter and air
filter and clean as indicated
below:
5. Foam Pre-filter
• Clean foam filter in water/
detergent solution and rinse
with clean water.
• Wrap the filter in a clean, dry
cloth and squeeze (do not
wring) dry. Allow to dry
completely before reuse. Do not oil.
Dual Layer Air Filter
• Lightly brush debris from filter.
• Soak heavily soiled filters in water/detergent solution to loosen dirt,
then brush lightly.
• Rinse with clean water and allow to dry completely before reuse.
6. Place foam pre-filter over raised center and inside outer lip of air filter.
Install air filter in air filter case.
7. Install air filter retainer on post in air filter cover, flat side up.
8. Install air filter cover and tighten cover knob securely.
X7502028004
© 02/21 ECHO Incorporated
Tune-Up Kit
]
MAINTENANCE
35