To Advance Trimmer Line; Remove Nylon Line Head; Support Handle Installation - Echo SRM-266 Operator's Manual

SRM-266
Semi-automatic nylon line heads must be used only with debris
shield with cut-off knife. Using nylon line heads with debris shield
without cutoff knife can result in trimmer damage, caused by
operation with excessive line length.
Note: Your nylon line head may appear different than nylon line
head shown.

To Advance Trimmer Line

See Maintenance Section for nylon line replacement.
Note: To advance trimmer line, tap trimmer head against the ground
while the head is turning at normal operating speed.

Remove Nylon Line Head

Note: Do not disassemble nylon
line head.
1. Align locking hole in upper plate
with notch in edge of gear
housing and insert head locking
tool (D).
2. Remove line head (E) by turning
it clockwise until head is
completely off of shaft.
3. Remove locking tool (D).

Support Handle Installation

Note: Label shows minimum
spacing for support handle
location.
1. If necessary, position support
handle for comfortable operation
and securely tighten screws.
X7502028004
© 02/21 ECHO Incorporated
ASSEMBLY
D
E
MINIMUM
SPACING
19