Table of Contents
Advertisement
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. In
order to remove any water which may
be left over from the test, run the first
washing cycle without any laundry.
Notes
The washing machine must be
■
correctly installed and connected.
(from ~ Page 42).
Never use a damaged machine.
■
Inform customer services.
Preparatory work:
Check the machine.
1.
Remove the protective film from the
2.
control panel.
Connect the mains plug.
3.
Turn on the tap.
4.
Run the programme without laundry:
Switch on the appliance.
1.
Close the door (do not load any
2.
laundry).
Set the Drum clean 90 °C
3.
programme.
Open the detergent drawer.
4.
Pour approximately 1 litre of water
5.
into compartment II.
Pour standard detergent into
6.
compartment II.
To prevent foaming, only use
Note:
half of the amount of detergent
recommended by the detergent
manufacturer. Do not use detergents
designed for woollens or delicates.
Close the detergent drawer.
7.
Press the Ü button.
8.
Switch off the appliance at the end of
9.
the programme.
Your washing machine is now ready to
use.
Positioning and connecting
en
49
Advertisement
Table of Contents
