Table of Contents
Advertisement
Faults and what to do about them.
en
Faults
Odours in the washing
machine.
The o symbol lights up
on the display panel.
Foam may also be leaking
from the detergent
drawer.
Loud noises, vibrations
and machine "movement"
during the spin cycle.
The display panel/
indicator lights do not
work while the appliance
is running.
There is detergent
residue on the laundry.
In the "Reload" status, Ü
flashes very quickly and a
signal sounds:
If you cannot rectify a fault yourself (after switching the machine off and on again) or a repair is required:
Switch off the appliance and pull out the mains plug.
■
Turn off the tap and call the after-sales service.
■
38
Cause/remedy
Run the Drum clean or Cotton 90 °C programme without laundry.
Add washing powder or a detergent containing bleach.
Note: .
To prevent foaming, only use half the amount of detergent
recommended by the detergent manufacturer. Do not use detergents designed
for woollens or delicates.
Have you used too much detergent?
Mix one tablespoon of fabric softener with 1/2 litre of water and pour it into
compartment II (not suitable for outdoor clothing, sportswear or items made
with down).
Use less detergent in the next washing cycle.
Appliance aligned? Align the appliance. ~ Page 48
■
Are the appliance feet secured? Secure the appliance's feet. ~ Page 48
■
Have the transport braces been removed? Remove the transport braces.
■
~ Page 44
Power failure?
■
Have the fuses blown? Switch on/replace the fuses.
■
If the fault occurs repeatedly, call the after-sales service.
■
Some phosphate-free detergents contain water-insoluble residue.
■
Select Rinse / Freshen Up or brush the laundry after washing.
■
The water level is too high. It is not possible to add laundry. Close the door
■
immediately, if necessary.
Press the Ü button to continue the programme.
■
Advertisement
Table of Contents
