Change The Programme Default Settings; Select Additional Programme; Settings; Placing Laundry Into The Drum - Siemens WM16Y792GB Instruction Manual And Installation Instructions

Operating the appliance
en
Change the programme
default settings
You can use or change the default
settings for each washing cycle.
To do this, repeatedly press the
corresponding button until the required
setting is displayed. ~ Page 12
Pressing and holding the buttons
Note:
automatically runs through the set
values.
The settings are activated without
needing to be confirmed.
The settings are not saved after the
washing machine is switched off.
Programme default settings
~ Page 22

Select additional programme

settings

By selecting additional settings/options,
you can better adapt the washing
process to your items of laundry.
The settings can be selected or
deselected depending on the progress
of the programme. ~ Page 12
The ecoPerfect ¦ and speedPerfect (
button indicator lamps light up if a
setting is activated.
The other settings are indicated by a
symbol on the display panel if the
setting is activated.
For multi-level settings, press and hold
the buttons to run through the settings
automatically.
The settings are not saved after the
washing machine is switched off.
Additional programme settings/options
~ Page 23
26

Placing laundry into the drum

:
Warning
Risk of death!
Items of laundry pretreated with
cleaning agents that contain solvents,
e.g. stain remover/cleaning solvent,
may cause an explosion after being
loaded into the washing machine.
Hand-rinse these items of laundry
thoroughly beforehand.
Load the pre-sorted, unfolded laundry
into the drum. The load screen for the
selected programme (e.g. for
Easy-Care) is indicated on the display
panel.
The load bar fills as the laundry is
loaded. If the maximum load is
exceeded, the bar flashes. Observe the
maximum indicated load. Overfilling
adversely affects the washing result and
encourages creasing.
Notes
Mix items of laundry of varying sizes.
■
Laundry items of different sizes
distribute themselves better during
the spin cycle. Individual laundry
items may cause an unbalanced
load. ~ Page 31
Wait until the Siemens logo no
■
longer appears before adding
laundry.
The load screen appears when the
■
door is opened or when the amount
of laundry is changed.