Page 2
TX7301 Intelligent Sounder Strobe Installation & Operation Manual Product Safety To prevent severe injury and loss of life or property, read the instruction carefully before installing the Sounder Strobe to ensure proper and safe operation of the system. European Union directive...
1 Introduction 1.1 Overview The TX7301 Intelligent Sounder Strobe is alarm warning device used to notify persons in the vicinity of the occurrence fire emergency in order the person to take appropriate measures. The unit adopt multi-application device starting from the types, parameters and wiring layout in single unit. The TX7301 can change into different alarm warning types such as sounder-strobe type, sounder type or strobe type using programming tool.
TX7301 Intelligent Sounder Strobe Installation & Operation Manual 2 Installation 2.1 Installation Preparation This alarm warning device must be installed, commissioned and maintained by a qualified or factory trained service personnel. The installation must be installed in compliance with all local codes having a jurisdiction in your area or BS 5839 Part 1 and EN54.
TX7301 Intelligent Sounder Strobe Installation & Operation Manual Figure 3 With External Supply Figure 4 Loop Powered 3 Sounder Strobe Configuration 3.1 Preparation The TX7930 handheld programmer is used to configure sounder strobe soft address and parameters. This tools are not included, must be purchased separately. The programmer is packed with twin 1.5V AA battery and cable, ready for usage once received.
TX7301 Intelligent Sounder Strobe Installation & Operation Manual 3.2 Addressing 1. Connect the programming cable to Z1 and Z2 terminals (Figure 5). Press “Power” to switch on the unit. 2. Switch-on the programmer, then press button “Write” or number “2” to enter Write Address mode (Figure 6).
TX7301 Intelligent Sounder Strobe Installation & Operation Manual 1. Attach the programming cable to 1 and 6 Terminals of sounder. Press “Power” to switch-on the unit. 2. Switch-on the programmer, then press button “3” to enter to Configuration mode (Figure 9).
TX7301 Intelligent Sounder Strobe Installation & Operation Manual 5 Troubleshooting Guide What you notice What it means What to do The wiring is loose Conduct maintenance Address not enrolling The address is duplicate Re-Commission the device Unable to commission The damage the electronic circuit...