Installation - Cooke & Lewis CLCGLEDB60 Manual

This involves no risk of damage. Switch off the electricity supply to the hood and reconnect after
one minute.
WARNING: This appliance can be used by children aged from 8 years and above and persons
5
with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they
have been given supervision or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision. Keep the appliance and its supply
cord out of the reach of children less than 8 years old.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
5
similarly qualified persons in order to avoid a safety hazard.
Do not install the appliance outdoors in a damp place or in an area which may be prone to water
5
leaks such as under or near a sink unit. In the event of a water leak affecting the appliance, do not
use and contact customer services to arrange for inspection.
Do not use flammable sprays in close vicinity to the appliance.
5
Please dispose of the packing material carefully. There is a fire risk if cleaning is not carried out in
5
accordance with the instructions. Refer to the Care and Maintenance sections carefully for details
on how to clean and replace the aluminium and carbon filters (if fitted).
Refer to the Care and Maintenance section for details on the type of lamps that can be used and
5
how to replace them.
Do not use a steam cleaner for care and maintenance.
5
The appliance is not intended to be operated by means of an external timer or separate remote
5
control system.
There shall be adequate ventilation of the room when the hood is used at the same time as
5
appliances burning gas or other fuels. Ensure that the negative pressure of the installation site
does not exceed 4 Pa (0.04 mbar) to ensure combustion fumes are not drawn back into the room.
Do not use the hood if it shows signs of damage or imperfection. Contact customer services
5
for assistance.
The manufacturer declines all liability for personal or material damage as a result of misuse or
5
incorrect installation of this appliance.
The appliance is for domestic use only as an extractor hood.
5

Installation

All installation must be carried out by a competent person or qualified electrician. Before connecting
the mains supply ensure that the mains voltage corresponds to the voltage on the rating plate.
Direct Connection
The appliance must be connected directly to the mains using an omnipolar circuit breaker with a
minimum opening of 3mm between the contacts.
The installer must ensure that the correct electrical connection has been made and that it complies
with the wiring diagram.
The cable must not be bent or compressed.
Regularly check the power plug and power cord for damage. If the supply cord is damaged, it must
be replaced by a special cord or assembly available from the manufacturer or its service agent.
WARNING: This is a Class II appliance and MUST NOT be earthed
GLOA10327_SM - 100000032-100000033 Chimney v5_r.indd 3 10/05/2017 18:35