Table of Contents
Advertisement
Quick Links
¤
20 OZ. AIR GRAVITY SPRAY GUN
Model 91009
ASSEMBLY and OPERATING
INSTRUCTIONS
®
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our Web site at http://www.harborfreight.com
©
®
Copyright
2003 by Harbor Freight Tools
. All rights reserved. No portion of this
manual or any artwork contained herein may be reproduced in any shape or form
without the express written consent of Harbor Freight Tools.
For technical questions and replacement parts, please call 1-800-444-3353
Advertisement
Table of Contents
Related Manuals for Central Pneumatic 91009
Summary of Contents for Central Pneumatic 91009
- Page 1 . All rights reserved. No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools. For technical questions and replacement parts, please call 1-800-444-3353...
-
Page 2: Specifications
Wear restrictive hair covering to contain long hair. Use eye and ear protection. Always wear ANSI approved impact safety goggles. Wear an ANSI approved dust mask or respirator when working around chemical dusts, paints and mists. Wear appropriate ear protection. Page 2 SKU 91009... - Page 3 20. Compressed air only. Never use combustible gas as a power source. 21. Do not spray near open flames, pilot lights, stoves, heaters, or any other heat source. Most solvents and coatings are highly flammable, particularly when sprayed. Page 3 SKU 91009...
- Page 4 Unpacking When unpacking, check to make sure the parts listed on page 8 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual as soon as possible.
-
Page 5: Operation
For best service you should incorporate a regulator and inline filter, as shown in the diagram above. Hoses, couplers, regulators, and filters are all available at Harbor Freight Tools. You will need to prepare a 1/4” air connector (sold separately) to connect to the air inlet on the Spray Gun. - Page 6 To change the spray pattern, turn the Spray Regulating Knob (20) and/or adjust the Air Nozzle (1). To regulate the amount of material entering the Spray Gun, adjust the Fluid Control Knob (12). To fine tune the air flow, adjust the Air Adjusting Valve (31). Page 6 SKU 91009...
-
Page 7: Troubleshooting
(8). If it is not clean, use the Brush (33) to clean it. Replace the Filter (27) and thread on the Cup (28). See FIGURE 3 on page 8. Use the Brush (33) to clean the recessed, hard to reach areas of the Gun. Page 7 SKU 91009... -
Page 8: Parts List
REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO. NOTE: Some parts are listed and shown for illustration purposes only and are not available individually as replacement parts. Page 8 SKU 91009... -
Page 9: Assembly Drawing
Assembly Drawing Page 9 SKU 91009... - Page 10 90 Day Warranty Harbor Freight Tools Co. makes every effort to assure that its products meet high quality and durability standards, and warrants to the original purchaser that this product is free from defects in materials and workmanship for the period of 90 days from the date of purchase. This...
Need help?
Do you have a question about the 91009 and is the answer not in the manual?
Questions and answers