Table of Contents
Advertisement
Display
PM10, PM2.5, PM1.0 identification display
01
Gas identification indicator
02
03
Checking before Use of Filter
• If you operate the air purifier with no filter, its purification effect decreases.
• At the initial stage of use, new filters may smell bad a little.
‐ If you operate it for a day, the smell disappears.
• If you operate the air purifier after 2 weeks or more or bad odour comes out, set the fan speed to High and
run the air purification for at least 4 hours while ventilating the area.
• Close windows and doors during operation. Periodically ventilate the air to avoid high concentration of
carbon dioxide when the room is closed for a long time.
• The cycles for filter cleaning and replacement may differ depending on the environment. You are charged
for the service.
• The indicator illuminates to notify when the filters need to be replaced.
However, if the filters are too dirty or smells bad or the fan speed is lowered rapidly, replace them with
new ones even if the indicator does not illuminate.
• In case of first use or replacement, be sure to remove the vinyl from filters.
01 PM10, PM2.5, PM1.0, GAS cleanliness colour display
02 PM10, PM2.5, PM1.0, GAS status display
03 PM10, PM2.5, PM1.0 concentration display
• Air quality levels
Pollution level
concentration
Very poor Red
151 and over
Poor
Yellow
Moderate Green
Good
Blue 30 and below
‐ PM10, PM2.5 and PM1.0 measurement will be displayed in
numbers 05 – 999.
PM10
PM2.5 / PM1.0
concentration
(㎍/m³)
(㎍/m³)
76 and over
81 - 150
36 - 75
31 - 80
16 - 35
15 and below
Gas pollution
level
4
3
2
1
English
9
Advertisement
Table of Contents
