Advertisement
4.2 Installation Procedure of 802CI2 PC Card
Note: Do not insert the PCMCI card until you are asked to do so, failure of which may result in
unsuccessful installation of your PCMCIA WLAN card.
Please follow the following steps one by one in order to install the PCMCIA card successfully.
1.
Power on your computer and allow Windows 95 / 98 to load fully.
2.
Be sure that there is no PCMCIA adapter inserted yet.
3.
Insert the given Installation Diskette and then click on the A:\disk1\setup.exe.
4.
Accept the license agreement.
5.
Give the path of the destination folder. To set the path of your choice click on Browser and then
click Next.
6.
It takes a few seconds for copying the utility files and then click on Finish to complete the
installation.
7.
Insert the 802CI2 card into PCMCIA slot; windows will then prompt the required driver.
8.
Locate the driver path Ex. A:\ and install the driver
9.
Restart the PC and Click on the Control Panel and then on PC Card. Check whether it has
PCMCIA card in one of the sockets or not. If you find 802CI2 PC Card in one of the sockets, it
means the card is detected properly.
10. Check for the 802CI2 Wireless PCMCIA LAN Card by right clicking on My Computer using the
mouse. Select the Device manager and then Network Adapters. If you find the sign on the
adapter, it shows the installation is not successful. Select the adapter and click on Remove.
Restart your computer after uninstalling the driver to make the changes effective. And refer to
manual.
11. Right click on the Network Neighborhood using the mouse.
12. Select Properties from the pop up menu. The network box appears and you see the three main
tables: Configuration, Identification, and Access Control.
13. Click on the Configuration tab and then click on the Add button. Select Network Component
Type box appears. Click on the Protocol the click the Add button.
14. Select Network Protocols box appears. From the list of manufactures, click on Microsoft. From
the list of network protocols list, select NetBEUI, then click OK.
15. The NetBEUI protocol is now installed. After clicking on OK return back to Network Component
Type box.
16. Repeat the step 15 and 16 to add IPX/SPX protocol.
17. Repeat the step 15 and 16 to add TCP/IP protocol.
18. Click on the TCP/IP option for setting the IP address for your computer. You can select either
Static OR DHCP setting. If you use the static IP setup then enter the IP value, Subnet masking,
DNS, Domain / Workgroup name, and Gateway address values. After setting these parameter
appropriately, click OK to return to Network Component Type and you can select the File and
Printer Sharing options as well as the Access to your computer other users connected to that
network by setting the computer sharing options. Click on OK.
19. Screen message do want to restart your Computer will pop up. Select Yes. It will shut down your
computer and will restart.
Important: Restart your computer to make the changes effective before you reinstall the driver.
7
Advertisement
