GE GTD42EASJWW Installation Instructions Manual page 19

REVERSING THE DOOR
B REVERSING THE DOOR - GLASS
PANEL DOOR MODELS
1
Open the door approximately 130 degrees. With a
putty knife, remove the 4 plastic caps located
along the left side of the front panel and set them
aside.
2
Remove the bottom screw from each hinge (right
side) and partially insert them into each top hinge
hole on the left side.
NOTE: All 4 front panel hinge screws will now be
in the top hinge holes - 2 on the left and 2 on the
right.
3
Loosen each top hinge screw on right side.
Remove the door and place it on a protective flat
surface to avoid any damage.
Loosen each
top hinge screw
on right side
Installation Instructions
Plastic Cap (4)
Left side of
front panel
B REVERSING THE DOOR - GLASS
PANEL DOOR MODELS (cont.)
4
Remove both the blind plate and the striker plate
and install them in the opposite positions.
Blind
plate
5
Remove the 4 door hinge screws, 6 inside screws
and 2 pocket screws. Lift the inner door upwards
using a flat blade screwdriver.
Inside
screws
Door
hinge
screws
19
Striker
plate
Pocket screws
Inside
screw
Inner door
Outer door
Inside
screws