GE GTD42EASJWW Installation Instructions Manual page 18

REVERSING THE DOOR (cont.)
A REVERSING THE DOOR - SOLID DOOR
MODELS (cont.)
5
GTX52 model only: Remove 2 hinges and 8
screws (4 for the hinges and 4 for the outer door).
Remove the inner door by lifting it up, using a flat
blade screwdriver, and out.
Hinges
and Screws
Outer Door
Screw
6
GTX52 model only: Flip the inner door over.
Remove the dock by squeezing its tabs and
pulling it out. Remove the latch catch by sliding
down and pulling it out. Switch and install in the
opposite positions.
4
Switch and
install in
opposite
positions
Squeeze
1
2
and pull out
7
GTX52 model only: Flip the inner door back
over and rotate it 180°. Replace it back into the
outer door. Replace the 2 hinges and 8 screws
(4 for the hinges and 4 for the outer door).
Installation Instructions
Outer Door
Screws
Inner
Door
Outer
Door
3
Slide down and
pull out
A REVERSING THE DOOR - SOLID DOOR
MODELS (cont.)
8
Mount the door on the 2 upper left side hinge
screws installed in step 2. Move the hinge screws
loosened in step 3 into the lower left side screw
holes and firmly tighten all 4 screws.
Door
9
Install the 4 plastic caps removed in step 1 into
the 4 right side front panel holes.
Plastic Cap (4)
Right side of
front panel
NOTE: To return the door to the original setup, follow
these instructions, swapping "left" and "right".
When you finish
Plug the dryer back into
its electrical outlet.
18
Hang door and
tighten screws