First Use; Personalization; Acoustic Signals - AEG L74950 User Manual

8

First use

• Delay start
– The selected delay (20 hours max) set by means of the relevant button appears on the
display for about 3 seconds (for example
selected programme is displayed.
– The DELAY START symbol will appear on the display.
– The delay time value decreases by one unit every hour and then, when remains 1 hour,
the time decreases every minute.
• Incorrect option selection
– If an option which is not compatible with the set wash programme is selected, the
message Err is displayed for about 2 seconds and the yellow light of button 7 starts
blinking.
• Alarm codes
– In the event of operating problems, some alarm codes can be displayed, for example
(see chapter «What to do if...»).
• End of the programme
– When the programme has finished a blinking zero
disappears and the door can be opened.
Stand by
If your laundry is not removed within 10 minutes after the programme is finished, the
backlight of the display switches off and the energy saving system will be enabled. Only
the button 7 pilot light is blinking to indicate that the appliance has to be switched off. By
pressing any buttons the appliance will come out from the energy saving status and you
could set another washing programme or switch off the appliance.
9.8 - DELAY START
9.9 - CHILD SAFETY LOCK
First use
• Ensure that the electrical and water connections comply with the installation instruc-
tions.
• Remove the polystyrene block and any material from the drum.
• Before the first wash, run a cotton cycle at the highest temperature without any laundry
in the machine, to remove any manufacturing residue from the drum and tub. Pour 1/2
a measure of detergent into the main wash compartment and start the machine.

Personalization

Acoustic signals

The machine is provided with an acoustic device, which sounds in the following cases:
• at the end of the cycle
• in the event of operating problems.
By pressing the 3 and 4 buttons simultaneously for about 6 seconds, the acoustic signal is
deactivated (except for the events of operating problems). By pressing these two buttons
again, the acoustic signal is reactivated.
- symbol
- symbol
'), then the duration of the previously
is displayed, the DOOR symbol