Table of Contents
Advertisement
Positioning and connecting
en
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. To
remove any water that may be left over
from the test, run the first wash cycle
without any laundry.
Notes
The washing machine must be
■
correctly installed and connected.
(from ~ Page 28).
Never use a damaged machine.
■
Inform the after-sales service.
Check the machine.
1.
Remove the protective film from the
2.
control panel.
Connect the mains plug.
3.
Turn on the tap.
4.
Close the door (do not load any
5.
laundry).
Select the Cottons 90 °C
6.
programme.
Open the detergent drawer.
7.
Pour approximately 1 litre of water
8.
into compartment II.
Pour standard detergent into
9.
compartment II.
To prevent foaming, only use
Note:
half of the amount of detergent
recommended by the detergent
manufacturer. Do not use detergents
designed for woollens or delicates.
Close the detergent drawer.
10.
Select Start/Pause.
11.
Switch off the appliance at the end of
12.
the programme.
Your washing machine is now ready to
use.
34
Transportation
E.g. when moving house
Preparatory work:
Turn off the water tap.
1.
Reduce the water pressure in the
2.
supply hose.
Maintenance – filter in the water
supply ~ Page 22
Drain the remaining detergent
3.
solution.
Maintenance – detergent solution
pump blocked ~ Page 21
Disconnect the washing machine
4.
from the mains.
Remove the hoses.
5.
Installing the transport locks:
Remove the covers and keep them
1.
in a safe place.
Use a screwdriver if necessary.
Insert all 4 sleeves.
2.
Clip the mains cable securely in the
holders. Insert and tighten the
screws.
Before commissioning:
Notes
The transport locks must be
■
removed.
To prevent unused detergent from
■
flowing straight into the drain during
the next wash: Pour approx. 1 litre of
water into compartment II and start
the Drain programme.
Advertisement
Table of Contents
