Points Of Attention In Assembly; Damping Component; Test Program - Haier LMA0120WPAB0 Service Manual

Service Manual Service Manual
520-MABE1789
Model No:

4-7-2 Points of attention in assembly

● Fix the wiring in the control panel seat to its original position. Do not make it touch sharp corner
and mobile position. The space surrounding the computer sequencer is rather narrow. Please
dispose it carefully and do not make the transformer press the wires.
● Cofirm that the control panel seat is installed to proper position of the cabinet. Pay attention on
the adjusting of the gap between the control panel seat and the cabinet.
The cabinet and other tub component
1) Method of disassembling
A. Loosen the two motor bolt unit to dismantle the motor. To adjust the tension of the belt, loosen
the bolts and move the motor left and right .
B. Loosen the four fastening screws to dismantle the delivery shield.
C. Loosen the three fastening bolts to dismantle the drain motor.
D. In dismantling the drain valve, first loosen the screws, then rotate slowly to make it loose.
dismantle the drain valve.
E. In dismantling the inner tub,first take off the outer tub cover, then dismantle the pulsator, finally
dismantle the inner tub. Handle with care when taking the inner tub off from the outer tub.
2) Points of attention in assembly
● In installation of the drain valve, please smear a piece of 801 glue at the connection part
between the drain valve and outer tub and between the overflow hose and drain hose to guarantee
that the drain valve will not leak.
● In fastening the screws, make it tight without sliding.
● Take care not to scratch the cabinet and influence the appearance of the Machine.

4-8 Damping component

White
0030802045A
White
0030802045A

4-9 Test program

Software break: start up 'encender/apagar', then hold 'etapa' and 'programa' at the same time.
C1 Test: Hold 'Temperatura' and 'programma' at the same time,the press 'encender/apagar'.
C2 Test: Hold 'Temperatura' and 'programma' at the same time,the press 'Power'.
Press 'temperatura' in three seconds.Then Perform washing process.
C3 Test: On the basis of above C2 test,press 'temperatura' again, Dehydration test go on.
Digital tube displays 'B1'.Default displays '20',then press 'etapa' to change.
Digital tube displays '21',press 'Start/pause'.
Digital tube displays 'C1'. All lights are lit.1s after the digital tube and all the
lights flashing out 3 times, while the buzzer rang 3 times, and then power off.
Back
Front
14
Issue
Rev.
White
0030802045A
Yellow
0030802045
Then