Information On The Display - Bosch WT45N202GB Installation And Operating Instructions Manual

Information on the display

en
Y
Information on the display
I n f o r m a t i o n o n t h e d i s p l a y
Faults
ð on the display and
drying has stopped.
é on the display.
ó on the display.
I am unable to connect
to my home network.
The display goes out and
Start/Pause A flashes.
* Depending on how the appliance is equipped or the available accessory
--------
Note:
If you cannot rectify the fault yourself by turning the appliance off and then on again,
please contact our after-sales service.~ Page 51
44
Cause/remedy
Empty the condensation container and reinsert it.~ Page 30
■
Press Start/Pause A.
Once you have installed the optional drain hose*, make sure that it:
■
Is correctly connected ~ Page 39
Is free of kinks
Is not blocked or clogged, e.g. with deposits
Remove the fluff.~ Page 31
Press Start/Pause A.
Not a fault. The heat exchanger is being cleaned automatically. Do not pull out
the condensation container while this is displayed.
Wi-Fi is switched off.To connect to your home network, switch on Wi-Fi. |
■
must appear on the display.
Wi-Fi is switched on but a connection to your home network cannot be
■
established.Check whether your home network is available or try to con-
nect to your home network again.
Not a fault. Energy saving mode is active .