Resetting Your Network Settings; Updating The Software - Bosch WT45N202GB Installation And Operating Instructions Manual

Notes
If Wi-Fi is switched off on the
■
appliance, the appliance cannot be
connected to your home network or
the app.
If Wi-Fi is switched on on the
■
appliance, when it is in Energy
saving mode, the appliance will not
automatically switch itself off.
If Wi-Fi is switched on on the
■
appliance and you wish to switch it
off, you must perform all these steps
again.
Resetting your network
settings
You can clear the network settings and
break the connection to your
smartphone or tablet PC by resetting
the network settings.
Switch on the appliance.
1.
Press and hold Remote Start } for
2.
at least 3 seconds.
'ž£ (connect automatically) will
appear on the display.
Turn the programme selector to
3.
position 5.
§"à (reset network settings) will
appear on the display.
Press Start/Pause A.
4.
¢"à (yes) will appear on the display.
Press Start/Pause A to confirm.
5.
"Ÿš (end) will appear on the display.
The network settings have now been
reset. Your appliance is no longer
connected to your home network or the
Home Connect app.
Press Remote Start } briefly to exit
6.
the Home Connect settings.
Notes
If the network settings could not be
■
reset, "§§ (fault) will appear on the
display.
If you want to operate the appliance
■
via the Home Connect app again,
you will need to reconnect it to your
home network and to the
Home Connect app either
automatically or manually.

Updating the software

You can update the Home Connect
software on your appliance. Whenever a
new update is available, —˜š (update)
will appear on the display.
You can install the update directly via
the message on the display or,
alternatively, you can do this manually.
Home Connect
en
37