en Basic operation
Switching off the appliance
Press
.
1.
Unplug the mains plug.
2.
Briefly pull on the mains power
3.
supply cord and then let go.
a The power cord retracts automatic-
ally.
Transporting the appliance
Switch off the appliance.
1.
Stand the appliance upright on its
2.
end.
Slide the catch on the floor tool
3.
into the groove on the underside of
the vacuum cleaner.
→ Fig.
10
To overcome obstacles, transport
4.
the appliance by the handle.
Controlling the power
You can control the setting continu-
ously.
Turn the power control to the re-
1.
quired setting.
→ "Overview of the controls",
Page 30
→ Fig.
11
Turn the telescopic tube with air
2.
flow regulator to the required posi-
tion.
→ Fig.
12
a The power is controlled continu-
ously.
Setting the floor tool
Use the switch to set the floor
▶
nozzle to the required base.
→ Fig.
13
1
Depending on the appliance specifications
32
Overview of the floor nozzle
settings
Here, you can find an overview of the
floor nozzle settings.
Vacuuming with accessory
1.
2.
Vacuuming with the Multi-
Use-Brush
1
Note: Do not remove the Multi-Use-
Brush after use. The suction power is
not restricted by the fitted Multi-Use-
Brush.
ATTENTION!
Vacuuming without the bristle ring
pushed down can damage the sur-
face.
▶
1.
2.
3.
a The Multi-Use-Brush is ready to
4.
Symbol
Use
Vacuum rugs and carpets.
Vaccum parquet and hard floors.
Place the required nozzle onto the
telescopic tube or the handle.
After use, take the nozzle that is
used from the telescopic tube or
remove from the handle.
1
Never vacuum with the bristle ring
pushed up.
Push the Multi-Use-Brush onto the
handle or the tube and lock it in
place.
→ Fig.
14
Press the two locking catches on
the bristle ring.
Push the bristle ring down and
lock it in place.
→ Fig.
15
use.
Vacuum using the Multi-Use-Brush.