CabCAM A-CC7M2CQR Operating Instructions Manual page 14

7.3 Jump Key Setting
CAMERA
OSD
SYSTEM
TRIGGER
TRIGGER
RESET
LEFT
RIGHT
FRONT
BACK
QUAD
DUAL
TRIPLE
PIP1
PIP2
PIP3
REC-V OUT:
To set the camera input(s) to be recorded when connected to DVR via the green RCA wire.
Left-side, right-side, front view, rear view camera and quad view image can be selected.
AUTOSCAN:
To set the auto scanning function. When AUTOSCAN is set as ON,
monitor will automatically switch between connected camera inputs and quad image.
SCAN DELAY:
To set the switching time of AUTOSCAN. Switching time frame: 0-60 seconds.
JUMP KEY:
To set the shortcut display mode from the 13 modes to the left.It can be activated by jump key selector.
POWER ON:
To set the default display model from the 13 modes to the left or STANDBY mode.
BEEP:
To turn on / off the warning tone. Default setting is ON and there will be a beeping sound when menu is being operated.
SYSTEM:
To set TV system: PAL / NTSC.
DIMMER:
To set backlighting brightness level of screen. Five levels and AUTO option are available;the higher the level,
the brighter. When set as AUTO, backlighting automatically adjusts in accordance with the outer brightness.
MAIN MENU
SETUP
SETUP
SETUP
SETUP
PRIORITY
ALL
H-SPLIT
TREFOIL
Y-SPLIT
CAMERA
OSD
SYSTEM
S
TRIGGER
TRIGGER
PRIORITY
REC-V OUT
AUTOSCAN
SCAN DELAY
JUMP KEY
POWER ON
BEEP
SYSTEM
DIMMER
- 11-
MAIN MENU
SETUP
SETUP
SETUP
SETUP
_
+
/
SYSTEM SETUP
QUAD
OFF
01 SEC
LEFT
H-SPLIT
ON
NTSC
01