Fig. 55: Fitting The Wall Insert; Table 37: Tightening Torque (72011) - ABB HT575751 Operation Manual

Operation Manual / 4 Product description / A100-M axial
8 Disassembly and assembly / 8.10 Installing the compressor casing
Fitting the wall insert
Fig. 55: Fitting the wall insert
Part number
72011
Table 37: Tightening torque (72011)
1. Remove lifting device (90190/90195).
2. Slide wall insert (77000) into compressor casing up to stop and remove guide stud
(90319).
3. Secure wall insert with screws (72011) and washers (72008).
For assembly of the alternative air inlet, see section
© Copyright 2017 ABB. All rights reserved.
A170-M
M20
580 Nm
Removing / Installing air-inlets
HZTL4033_DE
A175-M
M24
1000 Nm
→52.
Revision B December 2017