Table of Contents
Advertisement
Specifications
Model
Power Supply
Dimension
(Width x Depth x Height)
Product Weight
• No further backflow protection required for connection to the water inlet.
Installation Place
Requirements
Before installing the appliance, check the following
information to make sure that the appliance should
be installed in a correct place.
Installation Location
• Install the appliance on a flat floor. (Allowable
slope under the appliance: 1°)
• Never try to level any uneven floor by putting
pieces of wood, cardboard or similar materials
under the appliance.
• If it is impossible to avoid positioning the
appliance next to a gas cooker or coal burning
stove, an insulation (850 X 600 mm) covered
with aluminium foil on the side facing the cooker
or stove must be inserted between the two
appliances.
• Ensure that when the appliance is installed, it is
easily accessible for an engineer in the event of
a breakdown.
• When installing the appliance, adjust all four feet
using the transit bolt spanner which makes the
appliance stable, and leave approximate 5 mm
for a clearance between the top of the appliance
and the underside of any worktop.
• Additional clearance should have 100 mm for
the wall and 20 mm for rear, right and left side.
10
FWV595**
220 - 240 V~, 50 Hz
600 mm X 560 mm X 850 mm
68 kg
20 mm
WARNING
• This appliance must only be used for domestic
household purposes and should not be used in
mobile applications.
NOTE
• If the appliance is installed on a raised platform,
it must be securely fastened in order to eliminate
the risk of falling off.
EN
100 mm
5 mm
20 mm
Advertisement
Table of Contents
