Using Remote Start - Clifford 4115X Owner's Manual

Using Remote Start

This feature allows you to remotely start and run your vehicle for a
programmable period of time. This makes it possible to warm up the
engine, and adjust the interior temperature of the vehicle with the cli-
mate control system. If interior heating or cooling is desired, the climate
controls must be preset, and the fan blower must be set to the desired
level prior to remote starting the vehicle.
Important! (1) Never remotely start the vehicle with the vehicle
in gear, and (2) Never remotely start the vehicle with the key
in the ignition.
Starting the Engine:
Make sure the parking brake is set. Press and release the remote
1.
control button once* (or the amount of times the system has been
programmed to activate the remote start).
2. The parking lights flash to confirm that the vehicle is attempting to
start. In gasoline vehicles the engine will start approximately four
seconds after the parking lights flash, in diesel vehicles the engine
starts after the WTS (WAIT-TO-START) timer has expired.
3. Once the vehicle has started, it will run for the pre- pro gram med
period of time (12, 24, or 60 minutes) or until a shutdown input
is trig gered.
* The factory setting is one press but this can also be programmed for
two or three presses maximum (see your authorized Directed installer
for the amount of presses programmed).
Record the number of presses to activate remote start here:
© 2016 Directed. All rights reserved.
3