Pairing A Remote Control - Clifford 4115X Owner's Manual

Pairing a Remote Control

Your system comes with the remote controls already programmed, how-
ever, if you are replacing or adding additional remote controls, they
must be paired to the system prior to operating the system. To pair the
remote, you need to know where the Control button is located. If the
horn honk is not connected, the main unit LED needs to be visible for
visual confirmation. If you cannot locate or access the main unit, it is
recommended that you visit your authorized dealer to pair the remote.
The system is capable of accepting up to four remote controls.
Turn key to the ON position
1.
Within 10 seconds, press and release Control button once.
2.
Within 10 seconds, press and hold the Control button. The LED
3.
on the module flashes one time and the horn honks (if connected)
to confirm entry into remote pairing. Do not release the Control
button.
Press the button on the remote control. The horn honks to confirm
4.
the remote has been paired.
Release the Control button.
5.
Turn the key to the OFF position. The horn sounds one long honk
6.
(if connected) to confirm that remote pairing has exited.
The programming routine exits if any of the following occurs:
The ignition is turned off.
•
There is no activity for 30 seconds.
•
The Control button is pressed too many times.
•
8
© 2016 Directed. All rights reserved.