Electrical Connections; Start-Up Of The Cabinet - Tefcold SCU1425 Instruction Manual

Electrical Connections

The appliance is intended for 220-240 V/50 Hz. The connection should be effected to an accessible
socket.
This appliance should have extra protection according to the power regulations. This is also the case
when replacing an existing appliance which does not have the extra protection.
Always use a 3 pin plug. The lead with green/yellow insulation should be earthed (marked
In all other cases an authorized electrician can tell you how to get the extra protection of the
appliance. In case there is no extra protection in the building, the Board of Electricity recommends
that an electrician installs a PFI or HPFI switch (contact breaker).
Start-up the Appliance
Before taking the appliance into use it is recommended to clean it – see section regarding
maintenance.
Important!
In case the cabinet has been lying down during transport leave it standing up for 2 hours before
switching it on.
The appliance should be connected to an 13A
protected socket.
The appliance should not be connected to a
multipoled distribution socket.
).
33