Chapter 9 Dtmf Functions; Manual Dialing; Dtmf Tx Hold; Automatic Dialer - Kenwood TH-F7A Instruction Manual

DTMF FUNCTIONS
The keys on the keypad also function as DTMF keys;
the 12 keys found on a touch-tone phone plus
4 additional keys (A, B, C, D). This transceiver also
provides 10 dedicated DTMF memory channels. You
can store a DTMF number (16 digits max.) with a
memory name (8 digits max.) in each of the channels
to recall later for speed dialing.

MANUAL DIALING

Manual Dialing requires only two steps to send DTMF
tones.
1 Press and hold the PTT switch to transmit.
2 While transmitting, press the keys in sequence on
the keypad to send DTMF tones.
• The corresponding DTMF tones are
transmitted and monitored through the speaker.
• While pressing keys on the keypad, the
transceiver remains in the TX mode. You do
not have to press [PTT] at the same time.
F e r . q
2 1 9 0
H ( ) z
6 7 9 1
7 0 7
4
8 2 5 7
9 1 4

DTMF TX HOLD

This function causes the transceiver to remain in
transmit mode for 2 seconds after you release each
key. So, you can release the PTT switch while
sending the DTMF tones.
1 Press [MNU] to enter Menu mode.
2 Turn the Tuning control or press [ ]/ [ ] to select
Menu No. 12 (DTMF HOLD).
3 Press [ ] or [MNU].
4 Turn the Tuning control or press [ ]/ [ ] to select
"ON".
5 Press [ ] or [MNU] to store the setting.
Otherwise, press [ ] or [PTT] to cancel.
30
3 1 6 3 4 1 7 7 6 1 3 3
2 3 A
5 6 B
8 9 C
0 # D

AUTOMATIC DIALER

If you use the 10 dedicated memory channels to store
DTMF numbers, you need not remember a long string
of digits.

STORING A DTMF NUMBER IN MEMORY

Note: Audible DTMF tones from other transceivers near you (or
from your own speaker) may be picked up by your microphone. If
so, you may fail to correctly program a DTMF number.
1 Press [MNU] to enter Menu mode.
2 Turn the Tuning control or press [ ]/ [ ] to select
Menu No. 10 (DTMF STORE).
3 Press [ ] or [MNU].
4 Turn the Tuning control or press [ ]/ [ ] to select
your desired DTMF memory channel number from
0 to 9.
5 Press [ ] or [MNU].
• The display for entering a memory name
appears; the first digit blinks.
• To skip naming the channel, press [ ] or
[MNU] again; jump to step 9.
6 Turn the Tuning control or press [ ]/ [ ] to select
a character. Refer to "NAMING A MEMORY
CHANNEL" {page 17} for the available characters
and the input method.
• You can enter alphanumeric characters plus
special ASCII characters.
• Press [MONI] to delete the charactor at the
cursor.
• You can also use the numeric keypad to enter
a character (special ASCII characters are not
available). For example, each press of [2]
switches entry as a, b, c, 2, A, B, C and then
back to a.
• While pressing and holding [LAMP], turn the
Tuning control to jump to the first character of
each ASCII character group {page 17}.
7 Press [ ] to move the cursor to the next digit.
8 Repeat steps 6 and 7 to enter up to 8 digits.