Cord, Hose & Accessory Storage; Extension Wands - RIDGID Pro Pack Plus WD10220 Owner's Manual

cord, hose & Accessory storage
1. Your Vac has convenient locations to
store your power cord, Vac hose, and
accessories.
2. Under the left cover of your Wet/Dry
Vac (as shown) is a storage location
meant to hold your superflex hose,
crevice tool and power cord. For ease
of storage, the hose should be folded
as shown and placed in the storage bin
to the far left. You will also notice a
rectangular feature in the bottom of this
bin. The crevice tool will easily store
standing up in this feature, tapered side
down. Additionally, the power cord will
also fit in this bin to the far right side.
Fold or wrap the cord in approximately
1-foot lengths until you get within a foot
of the storage bin.
The folded cord should now fit neatly
into the storage bin.
3. Under the right cover of your Wet/Dry
Vac (as shown) is a storage location
for the dusting brush and utility nozzle.
Each of these nozzles has a specific
location molded into the housing.
Only these two nozzles should be
stored in this location. Also located
inside this compartment is the blowing
port. Please see the "Blowing" section
for blowing directions.
4. To store the extension wands, snap
each extension wand into the extension
wand holder found on the back of the
unit.
Correct
Hose
Wrap for
Storage
Hose
Storage
Crevice
Tool
Storage
Power Cord
Storage
11
Blowing
Port
Utility
Nozzle
Storage
Dusting
Brush
Storage
Extension
Wands
Extension
Wand
Storage
Holder