Table of Contents
Advertisement
3-3
Removing the Heat Sink
Follow these instructions to remove/install the heatsink:
1.
Loosen the captive screws securing the heatsink in place in reverse order (4g3g2g1).
2.
Move the rotating wires into the unlatch position.
3.
Lift and remove the heat sink from the system.
4.
To reinstall the heat sink reverse steps 1-3 while ensuring that you tighten the captive screws in
sequential order (1g2g3g4) as seen in the image below.
2
3
When installing the heatsink to CPU, use T30-Lobe driver to tighten 4 captive nuts in sequence
as 1-4. The screw tightening torque: 8 ± 0.5 kgf-cm.
System Hardware Installation
3
1
1
4
2
- 26 -
Advertisement
Table of Contents
