Before First Use - Krups SAVOY BW311050 Manual

„ „
Never use scouring pads for cleaning purposes.
„ „
To remove the anti-scale filter, remove the kettle from its base and allow it to cool down.
„ „
Never remove the filter when the appliance is filled with hot water.
„ „
All appliances are subject to strict quality control procedures. These include actual
usage tests on randomly selected appliances, which would explain any traces of use.
„ „
Children should be supervised to ensure that they do not play with the appliance.
„ „
Keep the appliance out of reach of children.
„ „
Children should be supervised to ensure that they do not play with the appliance.
„ „
Never heat the kettle when it is empty.
„ „
Never fill the kettle past the maximum water level mark, nor below the minimum
water level mark. If the kettle is too full, some water may spray out.
„ „
KRUPS reserves the right to modify the characteristics or components at any time
in the interests of the consumer.
CAUTION: the safety precautions are part of the appliance. Read them
carefully before using your new appliance for the first time. Keep them in a
place where you can find and refer to them later on.
„ „
Remove all of the various packaging, stickers or accessories from both the inside
and outside of the kettle.
„ „
Adjust the length of the cord by winding it under the base. Wedge the cord into the
notch. (fig. 1)
„ „
Throw away the water from the first two/three uses as it may contain dust. Rinse the
kettle and the filter separately.
1. TO OPEN THE LID.
„ „
Press on the unlocking button. (fig. 2)
When you press on the unlocking button, the lid will open automatically. (fig. 3)
„ „
If the lid is lost or broken, please contact your after-sales service center.
2. PLACE THE BASE ON A FLAT, STABLE, HEAT-RESISTANT SURFACE AWAY
FROM WATER SPLASHES AND ANY SOURCES OF HEAT.
„ „
Your kettle must be used with the base and anti-scale filter specific to this product.
3. FILL THE KETTLE WITH THE DESIRED AMOUNT OF WATER. (fig. 4)
„ „
Never fill the kettle when it is on its base.
„ „
Do not fill it above the maximum level, or below the minimum level. If the kettle is too
full, boiling water may spill out. (fig. 5)
„ „
Do not use without water.
„ „
Check that the lid is closed properly before use. (fig. 6)
4. POSITION THE KETTLE ON ITS BASE. PLUG IT INTO THE SOCKET.
5. TO START THE KETTLE.
„ „
Press the on/off button at the bottom of the handle. The on/off button will light up. (fig. 7)

BEFORE FIRST USE

USE
3