Table of Contents
Advertisement
14
F
unction of each Button
POWER BUTTON
Use to turn the power on or off.
Push again and power goes on or off
The power goes off automatically about 10 seconds
after the wash is finished.
Soak, Spin Hold BUTTON
These buttons can be selectable for every
program.
Soak:It gives additional 30 min Soak.
(Except for Wool, Delicate, Rinse/Spin,
Spin Only) (refer to page 21)
Spin Hold: It gives gentle spin instead of
normal spin (Except for Wool, Delicate,
Wash Only) (refer to page 23)
Custom Program
BUTTON
This button allows
you to store a
customized wash
cycle for future
use .
(refer to page 24)
Note
* For optimizing the washing algorithm, the displaying time may be changed during washing-increased by 8minutes at
maximum and decreased by 4 minutes at maximum.
* If the Detergent quantity is put more than the standard, for increasing the rinsing performance, it automatically adds
rinsing, and the remaining time may be increased.
* The standard detected by the sensor changing the algorithm is set by the normal standard. It may not be same to the
washing habit of a specific user. So, it does not matter that the user uses it according to her/his washing habit.
SOIL LEVEL BUTTON
This button allows you to select
the strength of the wash action.
Power option selections light up
in sequence as follows Medium
Heavy
Light
Medium as
the button is pushed.
This can be selected for any
program, but when washing
Heavy, it starts with Heavy.
Adjustment can be made while
washing.
Delay Start (Reservation)
BUTTON
Use to set a delayed finishing time.
The time increases when the button is pushed.
The following settings are indicated as the button is
pushed 3
4
5
16
...46
48
To cancel delay time, turn the power switch off.
(refer to page 22)
WASHING CONDITION INDICATOR (OPTION)
• It only operates in FUZZY Program.
• During being detected by the sensor, the LED flashes green, orange and red in turn. And,
after detecting, the LED lights a specific color according to the detecting condition as
follows:
If the current washing condition (Detergent quantity, Water Temperature, water quality,
etc.) is determined as better than the standard one, it optimizes the algorithm to save the
energy by decreasing washing time/strength, and the LED automatically turns to red.
If the current washing condition is determined as worse than the standard one, it
optimizes the algorithm by increasing washing time/strength, and the LED
automatically turns to orange.
If the current washing condition is determined as equal to the standard one, the
algorithm has no change and the LED turns to green.
... 11
12
14
3 HOUR.
Advertisement
Table of Contents
