Saeco RI9946/47 Operation And Maintenance Manual page 58

50
maCHine WarninGS
Help Message Displayed
ROTATE THE MILK CARAFE DISPENSING
SPOUT INTO BREWING POSITION
ESC
ROTATE THE MILK CARAFE DISPENSING
SPOUT INTO RINSING POSITION
ESC
PLACE MILK CARAFE
IN ITS HOUSING
ESC
17/05/09
USER
MENU
SELECTED
USER
04:17 pm
17/05/09
USER
MENU
SELECTED
USER
04:17 pm
17/05/09
USER
MENU
SELECTED
USER
04:17 pm
17/05/09
USER BEVERAGE
MENU MENU
SELECTED SETTINGS
MENU
USER
04:17 pm
RESTART TO SOLVE
THE PROBLEM
(E xx)
How to Reset the Message
A beverage with milk has been selected. The machine requires the carafe handle
spout to be placed into dispensing position .
Press the button "ESC" to cancel the selection.
The carafe rinse function has been selected .
Press the button "ESC" to cancel the selection.
The selected operation requires the milk container for brewing. Insert the
container in the machine as specifi ed in the manual.
Press the button "ESC" to cancel the selection.
Perform a descaling cycle on the machine .
BENERAGE
When this message is displayed, it is still possible to use the machine, but its
MENU
correct operation might be compromised .
Damages caused by failure to descale the machine are not covered by warranty.
SETTINGS
MENU
The machine requests the "Intenza" water fi lter to be replaced with a new one.
BEVERAGE
MENU Replace the fi lter as described on page 7.
The alarm is displayed only if the "Filter Enable" function is set to "ON".
SETTINGS
MENU
(See page 36) .
The sensor for the Fingerprint Enable procedure is not working properly.
BEVERAGE
Clean it thoroughly .
MENU
If even after an thorough cleaning the failure is not solved, contact the service
SETTINGS
MENU
centre .
Flashing red light . Machine in Stand-by .
The Stand-by settings can be changed .
Press the "
An event has occurred which requires the machine restart. Take note of the code
(E xx) shown at the bottom.
Switch off the machine, wait 30 seconds and then switch it on again. If the
problem persists, contact the service centre .
" button.