Summary of Contents for Sunny Health & Fitness SF-XF9937
Page 1
DIP STATION STAND SF-XF9937 USER MANUAL IMPORTANT! Please retain owner’s manual for maintenance and adjustment instructions. Your satisfaction is very important to us, PLEASE DO NOT RETURN UNTIL YOU HAVE CONTACTED US: support@sunnyhealthfitness.com or 1- 877 - 90SUNNY (877-907-8669).
IMPORTANT SAFETY INFORMATION We thank you for choosing our product. To ensure your safety and health, please use this equipment correctly. It is important to read this entire manual before assembling and using the equipment. Safe and effective use can only be achieved if the equipment is assembled, maintained, and used properly.
PARTS LIST Description Qty. Description Qty. Bottom Frame Round Outer Pipe Plug Upright Tube Foam Support Tube Hollow Sleeve Connecting Tube Pull Pin Ordering Replacement Parts (U.S. and Canadian Customers only) Please provide the following information in order for us to accurately identify the part(s) needed: ...
Page 5
ASSEMBLY INSTRUCTIONS We value your experience using Sunny Health and Fitness products. For assistance with parts or troubleshooting, please contact us at support@sunnyhealthfitness.com 1-877-90SUNNY (877-907-8669). STEP 1: Attach 2 Connecting Tubes (No. 4) onto 2 Bottom Frames (No. 1). STEP 2: Attach 4 Upright Tubes (No.
Page 6
We value your experience using Sunny Health and Fitness products. For assistance with parts or troubleshooting, please contact us at support@sunnyhealthfitness.com 1-877-90SUNNY (877-907-8669). STEP 3: Attach 2 Support Tubes (No. 3) onto 4 Upright Tubes (No. 2) and secure with 8 Bolts (No.
Page 7
Support Tube Connecting Method 1 Support Tube Connecting Method 2 Support Tube Connecting Method 3...
MAINTENANCE INSTRUCTIONS DAILY MAINTENANCE Inspect and tighten all parts regularly. (Nuts, Bolts, Rubber Pads, Steel Brackets, etc.) Replace any worn or torn parts immediately. Check and ensure the bench is levelled at all time. Check and tighten all adjustment pins/knobs regularly. WEEKLY MAINTENANCE Use damp cloth on plastic parts only, use dry cloth on metal frames.