Advertisement
Line up the Velcro tape on the bottom of the suppressor with the Velcro tape on the surface and firmly press the
3.
suppressor onto the surface. Then, properly attach the green ground wire (12 AWG) coming out of the suppressor to a
grounding system. After grounding is complete, the suppressor is ready to be used inline with network equipment.
The facts and figures herein are carefully compiled to the best of our knowledge and are intended for general informational purposes only. Responsibility
for the use and application of AccelTex Solutions materials rests with the end user. All AccelTex Solutions products are sold pursuant to the AccelTex
Solutions Terms and Conditions of Sale. © 2018 AccelTex Solutions. All Rights Reserved. AccelTex, AccelTex Solutions, the AccelTex Solutions Logo and
other marks are trademarks or registered trademarks of AccelTex Solutions.
ETHERNET SURGE SUPPRESSOR GUIDE
Line Up Sides of Tape
Figure 10 - Line Up and Attach Suppressor (Ready to Ground)
ATS-SS-64V-10KA-10GBPS-BT
Press Down Firmly
7
1.888.406.8906
SALES@ACCELTEX.COM
Advertisement
