Advertisement
3. The suppressor can now be attached to a DIN rail using the DIN rail clip. Make sure the DIN rail clip is fully attached to
the DIN rail that is being used. Then, properly attach the green ground wire (12 AWG) coming out of the suppressor to
a grounding system. After grounding is complete, the suppressor is ready to be used inline with network equipment.
The facts and figures herein are carefully compiled to the best of our knowledge and are intended for general informational purposes only. Responsibility
for the use and application of AccelTex Solutions materials rests with the end user. All AccelTex Solutions products are sold pursuant to the AccelTex
Solutions Terms and Conditions of Sale. © 2018 AccelTex Solutions. All Rights Reserved. AccelTex, AccelTex Solutions, the AccelTex Solutions Logo and
other marks are trademarks or registered trademarks of AccelTex Solutions.
ETHERNET SURGE SUPPRESSOR GUIDE
Figure 6 - Attached to DIN Rail (Ready to Ground)
5
ATS-SS-64V-10KA-10GBPS-BT
1.888.406.8906
SALES@ACCELTEX.COM
Advertisement
