Accessories Warning - DeWalt DCST920P1 Instruction Manual

housing (14D) will be visible as shown in Figure 14. Insert screwdriver
through each all three holes to prevent the spool housing from turning.
2. Turn the spool housing clockwise as shown in Figure 15.
3. Insert a screwdriver back through the three holes (14A, 14C, and
14D) and thread the new spool housing counterclockwise and
securely tighten onto the bolt (15A) protruding from the trimmer.
FIG. 14
14A
G
14C
14D
14B
H
Replacing Guard (Fig. 16–17)
WARNING:
Never operate appliance without guard
firmly in place.
1. Remove the spool housing as described in the "Replacing Spool
Housing" section.
2. Remove the 4 guard screws (16A) shown in Figure 16.
3. Lift the guard off at an angle as shown in Figure 17.
FIG. 16
16A
16A
FIG. 15
15A
FIG. 17
4. To attached a new guard, slide the
tab (18A) of the new guard under the
lip (18B) of the motor housing (E),
then lower the back of the guard into
place as shown in Figure 18.
5. Replace and securely tighten the 4
guard screws (16A).
6. Replace the spool housing as
described in the "Replacing Spool
Housing" section.
Accessories
WARNING:
offered by D WAlT, have not been tested with this product, use of
e
such accessories with this appliance could be hazardous. To reduce
the risk of injury, only D WAlT recommended accessories should be
e
used with this product.
Recommended accessories for use with your appliance are available
at extra cost from your local service center. If you need any assistance
in locating any accessory, please contact D
701 East Joppa Road, Towson, MD 21286, call 1-800-4-D
(1-800-433-9258) or visit our website: www.dewalt.com.
Repairs
The charger and battery pack are not serviceable. There are no
serviceable parts inside the charger or battery pack.
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustments (including brush inspection and replacement) should
be performed by a D WALT factory service center, a D
e
authorized service center or other qualified service personnel. Always
use identical replacement parts.
12
FIG. 18
18B
18A
Since accessories, other than those
WALT Industrial Tool Co.,
e
WALT
e
WALT
e