AEG LAVAMAT 84749 User Information page 34

Operating Instructions
Problem
The drain pump runs
constantly - even when
the appliance is
switched off.
Fabric softener was not
rinsed in, compart-
ment æ for condition-
ers is filled with water.
Washing is heavily
creased.
The washing is not suf-
ficiently spun. Water is
left in the drum.
Error code
The door cannot be
opened when appliance
is switched on.
Remnants of detergent
are building up in the
detergent drawer.
34
The Aqua Control anti-flood
system has been activated.
The insert in the comparti-
ment for conditioners is not
correctly attached or is
blokked.
Probably too much washing
has been put in drum.
Drain hose is kinked.
Maximum pump height
(emptying height 1m from
base surface of the appli-
ance) is exceeded.
(2 .
appears
Drain pump is blocked.
At the siphon connection: Si-
phon is blocked.
The door is locked for safety
reasons (DOOR display is
OFF).
The programme security
function is On.
Water tap is not fully
opened.
The inlet hose filter in the
coupling of the inlet hose at
the tap is blocked.
Possible cause Remedy
Close the water tap, remove
the mains plug and inform
your local Service Force Cen-
tre.
Clean the detergent dis-
penser drawer and attach the
conditioner insert correctly.
Pay attention to the maxi-
mum load quantity (see pro-
gramme tables). In the case
of easy-care fabrics select
the EASY IRON programme.
Remove the kink.
Contact your local Service
Force Centre. For pumping
heights over 1 m a conver-
sion kit is available as a spe-
cial accessory.
Switch off appliance and pull
out the mains plug. Clean
the drain pump.
Clean siphon.
Wait until the DOOR display
lights up green.
Cancel programme security
(see section „Programme
protection").
Open water tap fully.
Close the water tap. Unscrew
the inlet pipe from water tap
and from the appliance and
clean the filter.