Advertisement
Assembly
NOTE: Hand tighten bolts and nylon nuts until machine is fully assembled.
13
STEP 2
Connect the Pull-up Bar (18) to the both of the Upper Upright Tubes (11) and secure
them with two M10 x 55 Bolts (A3) and two Washers D10 (B1).
Connect two Upper Upright Tubes (11) to the Lower Upright Tubes (6) and secure
them using four M10 x 20 Bolts (A1) and four Washers D10 (B1).
Attach the two Extend Arms (13) through the joints of the Upper and Lower Upright
Tubes (11 & 6) to the Upper Cross Brace (12). Secure them with four M10 x20 Bolts
(A1), two M10x70 Bolts (A2),and two M10 Nylon Locknuts (C1).
Connect the two Upper Support Bars (14) to both the Extend Arms (13) and the
Lower Upright Tubes (6). Secure them using four M10 x 70 Bolts (A2),
M10 Nylon Locknuts (C1).
C1
A1
A2
14
A2
11
B1
A3
C1
C1
A1
A1
C1
C1
B1
7
11
B1
A3
A2
12
A2
A1
A2
B1
6
and four
18
Advertisement
