Related Manuals for Mark Of Fitness XM-4446
Summary of Contents for Mark Of Fitness XM-4446
- Page 1 XM-4446 POWER TOWER Owner’s Manual !CAUTION Read all precautions and instructions in this manual before using this equipment.
-
Page 2: Table Of Contents
Table of Contents Before You Start Important Safety Information Assembly Parts List Exploded View... -
Page 3: Before You Start
CALL 1-800-719-4605 Monday-Friday 8:30 a.m.-5:00 p.m. XMARK FITNESS SERIES (Central Standard Time) MODEL: XM-4446 For Warranty information please visit www.xmarkfitness.com. When calling please have the following product information available: Model Name : XM-4446 Date Mfg.: Serial # Model Name Decal Location... -
Page 4: Important Safety Information
Important Safety Information Please read all instructions carefully before using this product. SAFETY TIPS Consult with your physician before engaging in any vigorous exercise. Know your heart rate and/or pulse as well as your physician-recommended heart rate training zone. Proper medical clearance is recommended for anyone beginning an exercise program especially if you are 35 years of age or older or suffer from heart respiratory problems. -
Page 5: Assembly
Assembly Hardware Identifier See the drawings below to identify the hardware used in the assembly. The number in paren- theses is the reference number of the part. Note: Some hardware may be pre-installed in some parts. M10 Nylon Locknut (C1) M10 Washer (B1) M8 Washer (B2) M10 x 20mm Bolt (A1) - Page 6 Assembly NOTE: Hand tighten bolts and nylon nuts until machine is fully assembled. STEP 1 Place the Left and Right Base (1 & 2) parallel to each other. Connect the Bottom Brace (9) to the Left and Right Base (1 & 2). Secure them with four M10x70 Bolts (A2), and four M10 Nylon Locknuts (C1).
- Page 7 Assembly NOTE: Hand tighten bolts and nylon nuts until machine is fully assembled. STEP 2 Connect the Pull-up Bar (18) to the both of the Upper Upright Tubes (11) and secure them with two M10 x 55 Bolts (A3) and two Washers D10 (B1). Connect two Upper Upright Tubes (11) to the Lower Upright Tubes (6) and secure them using four M10 x 20 Bolts (A1) and four Washers D10 (B1).
- Page 8 Assembly NOTE: Hand tighten bolts and nylon nuts until machine is fully assembled. STEP 3 Attach the two Armrests (19) to each of the Extend Arms (13) and secure them with four M8x70 Bolts (A4) and four Washers D8 (B2). Attach the Backrest Board (20) to the Upper Cross Brace (12) and secure it with two M8x40 Bolts (A5) and two Washers D8 (B2).
-
Page 9: Parts List
Parts List XM-4446 Parts List Key NO DESCRIPTION LEFT/RIGHT BASE LEFT/RIGHT BASE SHORT FOAM GRIP LOWER SUPPORT BAR 2" SQUARE SLEEVE LOWER UPRIGHT PROTECTIVE COVER ROUND PLUG, 25X1.5 BOTTOM CROSS BRACE ROUND INNER PLUG, 25x2 UPPER UPRIGHT TUBE UPPER CROSS BRACE... -
Page 10: Exploded View
Exploded View... - Page 11 Customer Service: 1-800-719-4605...