BASSFACE IndyEVO10/2RK Instruction Manual

BASSFACE IndyEVO10/2RK Instruction Manual

10" 2x2ohm 25cm dvc subwoofer recone kit

Advertisement

IndyEVO10/2RK 10" 2x2Ohm 25cm DVC
Subwoofer Recone Kit
Instruction manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the IndyEVO10/2RK and is the answer not in the manual?

Questions and answers

Summary of Contents for BASSFACE IndyEVO10/2RK

  • Page 1 IndyEVO10/2RK 10" 2x2Ohm 25cm DVC Subwoofer Recone Kit Instruction manual...
  • Page 2 Thank you for choosing Bassface. From the simplest connector to our top of the range amplifier - every element of these products has been designed to give you the best possible performance for your money. Please take the time to read these instructions carefully as they contain useful and important information.
  • Page 3 Begin by removing the old cone and coil from the woofer. Use a sharp knife, carefully cutting the surround, spider and tinsels. You can also use a heat gun (carefully!) to warm the parts to around 110 degrees. This will soften the adhesive sufficiently to strip the speaker without cutting.
  • Page 4 fit the dustcap we recommend to use strips of masking tape in closely arranged straight lines to form a circular mask - this will prevent excess glue from contaminating the new cone. Apply an even bead of adhesive and make sure the dust cap is pressed on centrally and firmly.

Table of Contents