Page 1
Alarm U Smoke User Manu Mode el number: : GS508C f:ST508C hall lway is more e than 30 fee t long, instal ll a smoke al larm at Thank k you for purc chasing our sm moke alarm. Please take a each h end.
Page 2
do not sense heat, flame, or gas. This smoke alarm is circuitry, horn, and battery are working properly. If no alarm designed to give audible warning of a developing fire. sounds, the battery may be depleted or another problem, refer However, many fires are fast - burning, explosive, or to “Trouble shooting”...
Page 3
SMOKE SENSING CHAMBER OPERATION: This alarm this warning tone for 10 hours, it will again prompt you to will “chirp” if any of the components in the smoke sensing replace the alarm after 10 hours. chamber fail. This chirp will occur between the flashes of the Maintenance and Cleaning: red LED indicator light.
Page 4
Repair: DEVELOP AND PRACTICE A PLAN OF Caution: Do not attempt to repair the alarm. This will void ESCAPE your warranty. If the alarm is not operating properly, and is still under warranty, return it to the original place of •...
Page 5
and spread horizontally. Mounting the smoke alarm on the ceiling in the center of the room places it closest to all points in the room. Ceiling mounting is preferred in ordinary residential construction. • For mobile home installation, select locations carefully to avoid thermal barriers that may form at the ceiling.
Page 6
(5mm) drill bit. Tap the two plastic grommets into holes with hammer. • Remove locking plug from the bracket with screwdriver if necessary (Refer to Diagram 6). This is an optional additional locking in place feature. • Mount the bracket to the ceiling by inserting and tightening the supplied screws into plastic grommets.
Page 7
• At this time, a red LED light up and indicating that the SITERWELL ELECTRONICS CO., LMITED ADDRESS:No.76 Haichuan Road, Chuangye Zone B , battery is discharging. • Wait for at least one day. , allow that the battery inside the...
Need help?
Do you have a question about the GS508C and is the answer not in the manual?
Questions and answers