Operating Instructions - Intex SF80220RC-1 Owner's Manual

OPERATING INSTRUCTIONS

RCD OPERATING INSTRUCTIONS
• Plug RCD into power outlet. Press RESET button on the RCD plug. Indicator
should be "ON". See FIG. 23.
• Press TEST button on the RCD plug. Indicator should be "OFF". See FIG. 24.
• Press RESET button for use. Do not use if test fails. Contact a qualified
electrician to determine cause of failure.
RESET
RESET
TEST
TEST
• Risk of electric shock. Connect this product only to a grounding type receptacle protected
by a ground-fault circuit interrupter (GFCI) or residual current device (RCD). Contact a
qualified electrician if you cannot verify that the receptacle is protected by a GFCI/RCD.
Use a qualified electrician to install the GFCI/RCD, which has a maximum rate of 30mA.
Do not use a portable residual current device (PRCD).
• To reduce the risk of electric shock, do not use extension cords, timers, plug adaptors or
converter plugs to connect unit to electric supply; provide a properly located outlet.
• Do not attempt to plug in or unplug this product while standing in water or when your
hands are wet.
• Never operate this product above the maximum working pressure stated on the filter tank.
• Always switch off pump before changing the 6-way valve position.
• Operating this product without water flowing through the system can cause a build up of
hazardous pressure which can result in an explosive situation, serious injury, property
damage or death.
• Never test this pump with compressed air. Never operate the system with water
temperature above 35°C (95°F).
6-way valve positions and function:
Valve Position
Normal filtration and regular vacuuming
FILTER
of pool
(see drawing 25)
Reverses water flow to clean filter
BACKWASH
media
(see drawing 26)
For initial startup cleaning of the sand, and
RINSE
(see drawing 27) leveling the sand bed after backwashing
For vacuuming directly to waste,
WASTE
lowering pool level or to drain the pool
(see drawing 28)
RECIRCULATE For circulating water back to pool
(see drawing 29) without going through the filter media
CLOSED Shuts off all flow to filter and pool
(see drawing 30) "Do not use this setting with pump running"
SAVE THESE INSTRUCTIONS
(195GS) SAND FILTER PUMP ENGLISH 7.5" X 10.3" PANTONE 295U 09/18/2017
23
RESET
WARNING
Function
24
RESET
RESET
TEST
TEST
TEST
Water Flow Direction
From pump through filter media to
pool
From pump through filter media to
valve waste/drain outlet
From pump through filter media to
valve waste/drain outlet
From pump to valve waste/drain
outlet bypassing the filter media
From pump through valve to pool
bypassing the filter media
195
English
GS
Page 14