elem Garden Technic TDE3213CBE21 Original Instructions Manual page 38

If you want to use an extension
cable when operating your
product, only the following cable
dimensions should be used:
– 1.0 mm²: max. length 40 m
– 1.5 mm²: max. length 60 m
– 2.5 mm²: max. length 100 m
Note: If an extension cable is
used it must be earthed and
connected through the plug to the
earth cable of your supply
network in accordance with
prescribed safety regulations.
If in doubt contact a qualified
electrician or the nearest ELEM
GARDEN TECHNIC Service
Centre / sav@eco-repa.com
WARNING! Inadequate
extension cables can be
dangerous. Extension cable, plug
and socket must be of watertight
construction and intended for
outdoor use.
Cable connections should be
kept dry and off the ground.
It is recommended for increased
electrical safety to use a Residual
Current Device (RCD) with a
tripping current of not more than
30 mA. Always check your RCD
every time you use it.
The connection lead must be
inspected for signs of damage at
regular intervals and may only be
used if in perfect condition.
If the supply cord is damaged, it
must be replaced by a ELEM
GARDEN TECHNIC Service
Centre / sav@eco-repa.com
DESCRIPTION
This product is intended for domestic lawn mowing.
It is not designed for commercial use.
1. Switch lever
2. Handle top
3. Switch case
4. Safety button
5. Wing nuts
6. Handle bottom
7. Grass bag
8. Deflector guard
9. Front cover
10. Wheels
11. Cable holder
ASSEMBLY «
The lawn mower is delivered unassembled. The
complete push bar must be assembled before
using the lawn mower. Follow the operating
instructions step-by-step and use the pictures
provided as a visual guide to easily assemble the
machine.
> Preparation
§ Put the cable hook on upper handle.
§ Connect upper and lower handles with supplied
screws and knobs.
§ Insert the handles into the mower body.
§ Fit each wheels over the axles, secure in place
with the "R" pins and press the wheel
covers into place.
§ Fix the cable holders.
§ Grasse collection box assembly. Assemble two
halves and fix them together.
§ Lift the flap and place the grass box over the lugs.
>
The grass catcher
To fit: Raise the rear cover and hitch the grass
catcher on rear of mower.
To remove: grasp and lift rear cover, remove
grass catcher.
Fig A »
38