Table of Contents
Advertisement
MAINTENANCES
Trouble Shooting
The start of the appliance does not work or it stops during operation.
First try to find a solution to the problem, If not, contact the service centre.
Description
No washing
No water flows in
Abnormal draining
Abnormal spin
Description
flare
flare
flare
flare
Note!
•
After the check, activate the appliance. If the problem occurs
shows other alarm codes
If the power is off or the fuse is burned out.
If the power supply voltage is too low.
If the water amount reaches to the required water level.(The washer will
not work if the water amount does not reach the required water level)
If it is set to "Delay" washing mode. (It will only start to work until the
reservation time reached)
If the power is off or the fuse is burned out.
If the water supply is cut off or the water pressure is too low.
If the inlet hose is properly connected and the water tap is opened.
If the filtering screen of inlet valve is blocked by dirt.
If the coil of inlet valve is damaged. (The slight electromagnetic sound is
normal phenomenon when the inlet valve is switched on)
If the "Start / Pause" button is pressed after the power switch is pressed.
If the water drain hose is placed very high.
If the end of water drain hose is sealed in pond.
If the internal rubber ring of drain valve is blocked by dirt.
If the door lid is closed.
If all clothing piled largely at one side of barrel or the clothing is excessively
placed.
If the washer is not placed in stable condition or it is placed in inclination
state. (The ground is not flat).
If the motor belt is loosened.
Reason
Alarm for abnormal
water intaking.
Alarm for lid not closed
before wash and spin.
Alarm for washing stay
at one side.
Alarm for water drain
has not finished.
again, contact the service.
Inspection Items
Check the water tap is
opened or not.
Closed the lid.
Manually balance clothes
in the barrel by hands.
Check the water level
sensor and drain pump.
10
20
Solution
or the display
Advertisement
Table of Contents
